For complete handpiece and chisel
specifications, actual size chisel profiles and dimensions, and dial
control/handpiece kits, click here.
The No. 50C comes with a set of 6 pre-sharpened steel cutters (AKHK550):
1. Gouge #3, Sweep Shallow Cut (A-KC503)
2. Gouge #7, Sweep Deep Cut (A-KC504)
3. Gouge #11, Sweep "U" Cut (A-KC505)
4. Parting Tool "V" Cut (A-KC506)
5. Chisel #1, Straight Single Bevel (A-KC509)
6. Chisel #2, Skew SIngle Bevel (A-KC510)
Foredom chisels will fit other power chisels including Proxxon and
22 Individual cutters are also available separately as kits and individual tools.
Flexcut RG tools are compatible with the Foredom No. 50 handpiece.
For more information about the compatibility of Flexcut tools with
reciprocating carver units, please visit our
Reciprocating Tool Reference Chart.
In addition, Flexcut also makes a Reciprocating Power Carving Handpiece that will attach to your existing Foredom machine.
Or buy the complete Flexcut SKX100 Professional RPC - Reciprocating Power Carver System , which includes:
Maintenance: After every 200 hours of use you should
clean and lubricate this handpiece. The old grease must be cleaned off
of the interior cam chamber and replaced with new lubricant. If you do
not have Foredom Grease (Part No. MS10008), it is available in our web
store under Suuplies and Parts - Lubrication- All Lubricants. Follow the
instructions that came with your handpiece or click on the link for step
by step maintenance instructions.
Operating Tip: Using the new chisel handpiece with a dial
speed control is easier than with a foot operated control. Table top
dial controls are available separately and named below. Consider
ordering a kit containing the chisel handpiece and dial speed control
(kit depends on motor -TX or SR- that you have). Certain Foredom bench
mounted flex shafts also come with dial controls built into their bases
(models SRM and TXM).
Dial Speed Controls:
Kits with Chisel Handpiece and Dial Speed Control (also includes 11